---

NOTE:

Stand ini hanya kompatibel untuk unit Durometer dari kami. Bila unit Durometer bukan dari kami, tidak dijamin kompabilitas konektornya, karena banyak Durometer versi tidak orisinil atau replica.

---

Stand holder untuk Durometer Shore-D

Untuk pengukuran yang lebih efisien waktu dan hasil yang lebih presisi

* Ini hanya stand holder saja, tidak termasuk Durometernya (kami juga menjual terpisah Durometernya di etalase toko)

Introduction:

This Durometer stand is specially equipped for Shore D Durometer, which can carry out accurate hardness testing on various materials

How to Use:

Place the sample on the circular platform, loosen the handle on the cross arm, adjust the height of the cross arm until the bottom surface of the presser foot is about 5 mm from the measured surface of the sample, and tighten the cross arm to lock the handle. Press down the handle to make the hardness tester press down under the gravity of the constant load weight, and read when the presser foot is in full contact with the sample within 1 second. The value displayed by the hardness tester is the hardness value of the tested sample. In order to improve the accuracy of the test, measure 5 times at different positions with a distance of at least 6mm between the measuring points and take the average value.

Specification:

Material: Iron + Marble + Tempered Glass

Purpose: It is suitable for hardness measurement.

Applicable Model: D Type Hardness Tester

Measuring Objects: Rubber, Sponge, Foam

Product Size: Approx. 160x120mm