Description
Reviews (0)

1. Feature

100MHz bandwidths
1GSa/s Real Time sample rate
Large (7.0-inch) color display,WVGA(800x480)
Record length up to 40K
Trigger mode: edge/pulse width/line selectable video/slop/overtime etc.
USB host and device connectivity, standard
Multiple automatic measurements
Four math functions, including FFTs standard
Provides software for PC real-time analysis
VGA Optional

2. Specifications

Model	DSO5102P
Acquisition
Sample Rate	Real-Time Sample: 1GS/s
Acquisition Modes
Normal	Normal data only
Peak Detect	High-frequency and randon glith capture
Average	Wavefom Average, selectable 4,8,16,32,64,128
Inputs
Inputs Coupling	AC, DC, GND
Inputs Impendance	1MΩ±2% ‖20pF±3pF
Probe Attenuation	1X, 10X
Supported Probe Attenuation Factor	1X, 10X, 100X, 1000X
Maximum Input Voltage	CAT I and CAT II: 300VRMS (10×), Installation Category; CAT III: 150VRMS (1×); Installation Category II: derate at 20dB/decade above 100kHz to 13V peak AC at 3MHz* and above. For non-sinusoidal waveforms, peak value must be less than 450V. Excursion above 300V should be of less than 100ms duration. RMS signal level including all DC components removed through AC coupling must be limited to 300V. If these values are exceeded, damage to the oscilloscope may occur.
Horizontal System
Sample Rate Range	500MS/s--1GS/s
Waveform Interpolation	(sin x)/x
Record Length	40K
SEC/DIV Range	4ns/div to 40s/div
Sample Rate and Delay Time Accuracy	±50ppm(at over any ≥1ms time interval)
Position Range	20ns/div to 80us/div; (-8div x s/div) to 40ms; 200us/div to 40s/div; (-8div x s/div) to 400s
Delta Time Measurement Accuracy (Full Bandwidth)	Single-shot, Normal mode:± (1 sample interval +100ppm × reading + 0.6ns); >16 averages:± (1 sample interval + 100ppm × reading + 0.4ns); Sample interval = s/div ÷ 200
Vertical System
Vertical Resolution	8-bit resolution, all channel sampled simultaneously
Position Range	2mV/div to 10V/div
Bandwidth	100MHz
Rise Time at BNC( typical)	3.5ns
Analog Bandwidth in Normal and Average modes at BNC or with probe, DC Coupled	2mV/div to 20mV/div, ±400mV; 50mV/div to 200mV/div, ±2V 500mV/div to 2V/div, ±40V; 5V/div, ±50V
Math	+, -, *, /, FFT
FFT	Windows: Hanning, Flatop, Rectamgular, Bartlett, Blackman; 1024 sample point
Bandwidth Limit	20MHz
Low Frequency Response (-3db)	≤10Hz at BNC
DC Gain Accuracy	±3% for Normal or Average acquisition mode, 5V/div to 10mV/div; ±4% for Normal or Average acquisition mode, 5mV/div to 2mV/div
DC Measurement Accuracy, Average Acquisition Mode	When vertical displacement is zero, and N ≥16:± (3% × reading + 0.1div + 1mV) only 10mV/div or greater is selected; When vertical displacement is not zero, and N≥16: ± [3% × (reading + vertical position) + 1% of vertical position + 0.2div]; Add 2mV for settings from 2mV/div to 200mV/div; add 50mV for settings from 200mV/div to 5V/div
Volts Measurement Repeatability, Average Acquisition Mode	Delta volts between any two averages of ≥16 waveforms acquired under same setup and ambient conditions
Trigger System
Trigger Types	Edge, Video, Pulse, Slope, Over time, Alternative
Trigger Source	CH1, CH2, EXT, EXT/5, AC Line
Trigger Modes	Auto, Normal, Single
Coupling Type	DC, AC, Noise Reject, HF Reject, LF Reject
Trigger Sensitivity (Edge Trigger Type)	DC(CH1,CH2): 1div from DC to 10MHz; 1.5div from 10MHz to 100MHz; 2div from 100MHz to Full; DC(EXT): 200mV from DC to 100MHz; 350mV from 100MHz to 200MHz; DC(EXT/5): 1V from DC to 100MHz;1.75V from 100MHz to 200MHz; AC: Attenuates signals below 10Hz; HF Reject: Attenuates signals above 80kHz LF Reject: Same as the DC-coupled limits for frequencies above 150kHz; attenuates signals below 150kHz
Trigger Level Range	CH1/CH2: ±8 divisions from center of screen; EXT: ±1.2V; EXT/5:±6V
Trigger Level Accuracy( typical)Accuracy is for signals having rise and fall times ≥20ns	CH1/CH2: 0.2div × volts/div within ±4 divisions from center of screen; EXT: ± (6% of setting + 40mV); EXT/5: ± (6% of setting + 200mV);
Set Level to 50%(typical)	Operates with input signals ≥50Hz
Video Trigger
Video Trigger Type	CH1, CH2: Peak-to-peak amplitude of 2 divisions; EXT: 400mV; EXT/5: 2V
Signal Formats and Field Rates, Video Trigger Type	Supports NTSC, PAL and SECAM broadcast systems for any field or any line
Holdoff Range	100ns ~ 10s
Pulse Width Trigger
Pulse Width Trigger Mode	Trigger when (< , >, = , or ≠); Positive pulse or Negative pulse
Pulse Width Trigger Point	Equal: The oscilloscope triggers when the trailing edge of the pulse crosses the trigger level. Not Equal: If the pulse is narrower than the specified width, the trigger point is the trailing edge. Otherwise, the oscilloscope triggers when a pulse continues longer than the time specified as the Pulse Width. Less than: The trigger point is the trailing edge. Greater than (also called overtime trigger): The oscilloscope triggers when a pulse continues longer than the time specified as the Pulse Width
Pulse Width Range	20ns ~ 10s
Slope Trigger
Slope Trigger Mode	Trigger when (< , > , = , or ≠ ); Positive slope or Negative slope
Slope Trigger Point	Equal: The oscilloscope triggers when the waveform slope is equal to the set slope. Not Equal: The oscilloscope triggers when the waveform slope is not equal to the set slope. Less than: The oscilloscope triggers when the waveform slope is less than the set slope. Greater than: The oscilloscope triggers when the waveform slope is greater than the set slope.
Time Range	20ns ~ 10s
Overtime Trigger
Over Time Mode	Rising edge or Falling edge
Time Range	20ns ~ 10s
Alternative Trigger
Trigger on CH1	Internal Trigger: Edge, Pulse Width, Video, Slope
Trigger on CH2	Internal Trigger: Edge, Pulse Width, Video, Slope
Trigger Frequency Counter
Readout Resolution	6 digits
Accuracy (typical)	±30ppm (including all frequency reference errors and ±1 count errors)
Frequency Range	AC coupled, from 4Hz minimum to rated bandwidth
Signal Source

Write a review

Your Name

Your Review

Note: HTML is not translated!

Rating Bad Good

Captcha

Please complete the captcha validation below

Oscilloscope HANTEK DSO5102P

Brand: Hantek
Product Code: DSO5102P
Availability: In Stock

Rp4,500,000
Ex Tax: Rp4,500,000

Qty

0 reviews / Write a review

Featured

Reflectance Meter Landtek RM-206

Alat ukur transparansi/ reflektifitas Digunakan untuk produk Plastik, Film, Coating, dll untu..

Rp9,900,000 Ex Tax: Rp9,900,000

Ultra Low Temperature Data Logger Tzone TempU06 L100

- Original TZONE versi Bahasa Inggris - Mendapatkan Sertifikat Kalibrasi yg berstandar NIST U..

Rp850,000 Ex Tax: Rp850,000

Magnetic Field Meter Tenmars TM-197

Original Tenmars Masih Made in Taiwan Bersertifikat Alat ukur medan..

Rp6,700,000 Ex Tax: Rp6,700,000

Battery Tester Ancel with Thermal Printer BST500

Alat ukur daya baterai dari ANCEL. Mudah digunakan Ideal untuk segala mobil dan truk. ..

Rp2,100,000 Ex Tax: Rp2,100,000

Vibration Calibrator Landtek VMC606

Alat kalibrasi Vibration Tester dari Landtek Memenuhi syarat industrial CE Menggunakan 4 ..

Rp9,100,000 Ex Tax: Rp9,100,000

Car Battery Tester AUTOOL BT860 with Printer

Car Battery Tester dengan layar LCD berwarna dan printer == AUTO BATTERY LOAD ..

Rp2,300,000 Ex Tax: Rp2,300,000

Laser Distance Meter CEM LDM100H

- Alat ukur jarak dimensi ruang dari brand CEM Instruments yang dikenal dengan kualitas baik ..

Rp1,000,000 Ex Tax: Rp1,000,000

Halogen Moisture Analyzer Joanlab MBA1002

Halogen Moisture Analyzer adalah alat ukur kadar air pada suatu material serbuk, makanan, hasil b..

Rp7,900,000 Ex Tax: Rp7,900,000

Gas Detector 4 In 1 Bosean BH-4M - H2S O2 CO LEL

Detektor 4 macam gas dari Bosean. Model terbaru. Industrial grade Anti-slip grip ru..

Rp3,650,000 Ex Tax: Rp3,650,000

Density Meter MH-300A

Density Meter digunakan untuk mengukur kepadatan atau massa jenis suatu material D..

Rp6,800,000 Ex Tax: Rp6,800,000

Salt Meter Kedida CT-3086 - Ukur Kadar Garam 0-5%

Kedida Tipe CT-3086 mengukur kadar garam dengan rentang 0.0 sampai 5.0% (Kami juga..

Rp870,000 Ex Tax: Rp870,000

Air Flow Meter MF5708

Alat pengukur laju oksigen/ nitrogen/ gas lain dengan display digital yang mudah dipakai dan ..

Rp4,900,000 Ex Tax: Rp4,900,000

Particle Counter CEM Instruments DT-9881

- Particle Counter spesifikasi tinggi dari CEM Instruments. Kualitas Industrial - Mengukur pa..

Rp25,000,000 Ex Tax: Rp25,000,000

Open Channel Flow Meter FM100V5

Open Channel Flow Meter digunakan untuk mengukur aliran air terbuka, Misalkan berupa parit, kanal..

Rp5,600,000 Ex Tax: Rp5,600,000

Infrared Sterilizer Joanlab DS900S

Sterilizer praktis dan efisien untuk alat lab, jarum, tabung dll Bahan stainless steel, mater..

Rp2,100,000 Ex Tax: Rp2,100,000

Ultrasonic Cleaner GT Sonic 20L Digital

- Note: Berat/Volume produk ini +-20kg Mesin pembersih dengan teknologi ul..

Rp11,000,000 Ex Tax: Rp11,000,000

Tablet Friability Tester CS-2

Alat uji kerapuhan tablet, umumnya untuk mengukur ketahanan permukaan tablet terhadap gesekan yan..

Rp9,800,000 Ex Tax: Rp9,800,000

$Refractometer Alcohol 0-80%$

Refractometer Alcohol 0-80%

Refraktometer 0-80 % ini mengukur kadar alkohol dari minuman/cairan. Ideal untuk industri mak..

Rp270,000 Ex Tax: Rp270,000

Earth Resistance Tester Peakmeter PM2302/MS2302

Digital Earth Ground Resistance Tester With 2 Pole And 3 Pole Mode English User Ma..

Rp2,500,000 Ex Tax: Rp2,500,000

Water Bath With Magnetic Stirrer Joanlab WBS-6Pro

Water Bath adalah alat laboratorium berbentuk wadah berisi air panas. Digunakan untuk menginkubas..

Rp5,000,000 Ex Tax: Rp5,000,000